The serial port number of the computer connected to the MegaPi is COM5 in this Manual).Ĭlick “Update Hex”, you will see a note as follow:Ĭlick “OK”, mLaser will automatically exit and then you need to reconnect USB. Select the serial port of the computer which connected to LaserBot (If there are multiple serial devices in the computer, you need to find the serial interface number corresponding to the MegaPi in the device manager. Supervisor password: makeblock321 (using supervisor password when you forget your own password)Ĭlick “Login” to access the lower-layer interface:Ĭlick “Test LaserBot” to access the interface as shown below:Ĭlick “Update Firmware”, you will see as follow :
(This step is necessary for the first use of LaserBot, and later you may directly skip to step 1)Īfter assembling LaserBot, start mLaser to access the log in interface:ĭefault login password: 123 (click “Set Password” on the right to set your own password) (Note: Please use English characters in the installation address.) 2.Software configuration
MLaser Github open source address Process Detailed instructions of mLaser 1.Software installationĭouble-click the downloaded mLaser installation package, and follow the instructions to install it. The mLaser teaching video enables you to quickly get familiar with the various features of the software. (Download LaserBot 3D model) mLaser Instructions Please construct LaserBot according to the video. LaserBot uses a beam of light to cut, engrave, and shape designs from a variety of materials.
Step2: DownLoad windows software ( Select the latest software Download ): NEJEV5.1.exe - 2020.4.2-Support firmware upgrade to version 6.2, if you don't like this firmware, you can use NEJEFirmwareCenter to change the firmware, Use software V4.7.2 directly. Step1: DownLoad windows driver: driver.exe.